Just got DONE
Just got DONE
Just got it done and still haven’t run the bike yet I get gas for it tomorrow.
2005 CRF450X TTM frame, 1995 CR500 Motor
2005 CRF450X TTM frame, 1995 CR500 Motor
Last edited by honda02 on May 28th, 2009, 10:33 pm, edited 2 times in total.
- NightBiker07
- Posts: 1942
- Joined: April 16th, 2008, 8:59 pm
- Location: USA
- dannygraves
- Posts: 8020
- Joined: June 1st, 2007, 2:03 pm
- Location: Las Vegas, NV
- britincali
- Posts: 8207
- Joined: May 31st, 2007, 7:10 pm
- Location: Barstow, CA
Not anymore
Yes it was it now a desert bike.
I tryed the 4 stroke thing with a KTM 560 ported tricked out just not the E ticket for me sold it and bullt this inplace of it the only thing I going to miss about the KTM is the E-Starter.
I tryed the 4 stroke thing with a KTM 560 ported tricked out just not the E ticket for me sold it and bullt this inplace of it the only thing I going to miss about the KTM is the E-Starter.
NightBiker07 wrote:is that Satan's Supermoto frame?
Murphy Law
It has a bad Stator figures.
I tryed to take out this morning it would not start tracked down to a bad stator it has a CR250 stator in it I just ordered a Ricky stator for it I should have sometime next week.
I tryed to take out this morning it would not start tracked down to a bad stator it has a CR250 stator in it I just ordered a Ricky stator for it I should have sometime next week.
Yes and NO
The CRF grapics gets them scracthing there heads I already had a guy confused what kind of bike it was I end up telling him It's a 2 Stroke then he was lost he had no idea what was up.
yota wrote:man thats beautiful, except the horror of the 4 stroke grapics (:
-
- Posts: 4394
- Joined: July 4th, 2007, 6:57 pm
Re: Not anymore
honda02 wrote:Yes it was it now a desert bike.
bitchin bike . is that the 2gal tank ? if so, a 500 will guzzle that pretty quick
Ok I took it out this morning and MR murphy Law showed his head Whats New It would not start.
After getting some tips from others It ended up beening my air gap was off on my stator, The carb float bowl leaks.
Now the Chucth Slips and it willn"t Idel .
I go down and try to find a clucth kit and a larger pilot jet for it tomarrow.
Will the AF convesion and moding the airbox make the bike not Idel.
I purchased the Donner bike fro $350.00 not running not knowing it need so much rework New case New trany.
After getting some tips from others It ended up beening my air gap was off on my stator, The carb float bowl leaks.
Now the Chucth Slips and it willn"t Idel .
I go down and try to find a clucth kit and a larger pilot jet for it tomarrow.
Will the AF convesion and moding the airbox make the bike not Idel.
I purchased the Donner bike fro $350.00 not running not knowing it need so much rework New case New trany.
The ring gap is always going to be in the rear for a 2 stroke and the cut out for the piston go's towards the intake.
JBaze wrote:Is it really hard to kick over like it's got a ton of compression? I had a bike that some expert rebuilt and put the piston in backwards. The bike ran but would not idle at all. Doing the conversion and airbox mods will not cause it not to run.
Last edited by honda02 on May 30th, 2009, 8:56 pm, edited 1 time in total.
- Wheelie-Gene
- Posts: 311
- Joined: May 26th, 2008, 11:52 am
- Location: stick country-TX
- Contact:
- Wheelie-Gene
- Posts: 311
- Joined: May 26th, 2008, 11:52 am
- Location: stick country-TX
- Contact: