Removing Flywheel

JakeBoucher · Post by **JakeBoucher** » July 21st, 2013, 1:24 pm

The Flywheel on my 85 CR500 has a little corrosion I would like to clean up. Pulled the nut off and obviously it didn't come off with a little tug. Anyway, where do I get a puller or what I need to get it off? Can I just buy a bolt with the correct threads, or would that be hard to find?

Nodge · Post by **Nodge** » July 21st, 2013, 2:05 pm

You need a flywheel puller.
If you try anything else, you will be sorry.

JakeBoucher · Post by **JakeBoucher** » July 21st, 2013, 3:37 pm

Where do I get the Flywheel puller? I looked on a couple sites and they don't carry one for the older models.

Nodge · Post by **Nodge** » July 21st, 2013, 4:01 pm

I ordered a whole kit full of pullers on eBay.

All you need is the 27mm puller for CR's.

Like so:
http://item.mobileweb.ebay.ca/viewitem? ... 0567958788

http://www.bikebandit.com/motion-pro-ma ... -left-hand

Any motorcycle shop can order you one.

JakeBoucher · Post by **JakeBoucher** » July 21st, 2013, 5:04 pm

Ok, thanks alot.

BannedCR500Riders.com

Removing Flywheel

Removing Flywheel