Removing Flywheel
-
- Posts: 8
- Joined: July 5th, 2013, 11:06 am
- Location: CA
Removing Flywheel
The Flywheel on my 85 CR500 has a little corrosion I would like to clean up. Pulled the nut off and obviously it didn't come off with a little tug. Anyway, where do I get a puller or what I need to get it off? Can I just buy a bolt with the correct threads, or would that be hard to find?
In the end were all just chalk lines on the concrete, drawn only to be washed away. - Ivan Moody 5FDP
You need a flywheel puller.
If you try anything else, you will be sorry.
If you try anything else, you will be sorry.
Yah, I'm from Saskatchetoon!
MRE 02 250/500 conversion, pulse injector, twirp porting, coolhead, MRE ignition, blah blah blah blah... www.millarengines.com
MRE 02 250/500 conversion, pulse injector, twirp porting, coolhead, MRE ignition, blah blah blah blah... www.millarengines.com
-
- Posts: 8
- Joined: July 5th, 2013, 11:06 am
- Location: CA
I ordered a whole kit full of pullers on eBay.
All you need is the 27mm puller for CR's.
Like so:
http://item.mobileweb.ebay.ca/viewitem? ... 0567958788
http://www.bikebandit.com/motion-pro-ma ... -left-hand
Any motorcycle shop can order you one.
All you need is the 27mm puller for CR's.
Like so:
http://item.mobileweb.ebay.ca/viewitem? ... 0567958788
http://www.bikebandit.com/motion-pro-ma ... -left-hand
Any motorcycle shop can order you one.
Yah, I'm from Saskatchetoon!
MRE 02 250/500 conversion, pulse injector, twirp porting, coolhead, MRE ignition, blah blah blah blah... www.millarengines.com
MRE 02 250/500 conversion, pulse injector, twirp porting, coolhead, MRE ignition, blah blah blah blah... www.millarengines.com
-
- Posts: 8
- Joined: July 5th, 2013, 11:06 am
- Location: CA