Cylinder - how's it look?

[torque monster]

Getting to the motor and the cylinder looks pretty dam nice, can still see the factory cross hatch pattern. I know it need a little updating on the ports but it looks as if this on is pretty fresh. Open to others opinion?




Here's the piston that came out, I have a fresh replacement.



It need a honed for sure, doesn't need a bore(I don't think atleast) and some port area work - ehaust bridge relief, etc. - what else?

Cheers
Chris

[britincali]

Did you order the piston yet? If not I would order one the next size up and have it bored to match.

[pstoffers]

Did you order the piston yet? If not I would order one the next size up and have it bored to match.

X9876787654323567889

[blownbillybob]

your the best judge sometimes pics. dont do it justice!!! look for vertical lines or groves in the cyl. mic. it if you can to see what your clearence is then go from there???? i just did my 91' cyl. a few months ago it looked decent but barely cleaned up at .010 over!!!!!!

[torque monster]

Going to Glenn @ GSS today.

[M.F.D.B.]

Now you are talking...

Always spend as much as you can afford especially if you are already going to have the motor apart. Its better to ride then wrench...

[sabreguy]

Going to Glenn @ GSS today.

You won't be disappointed.

[torque monster]

WOW is all I can say!!!

Got may parts back from GSS today and they look sweet!!!! Very fair price too might I add. Thanks Glenn!!

Still running stock bore, I thought the motor looked liked it had been bearly used - got a little luck there!

Cheers
Chris