Like the title says, Short Rod Piston with long rod compensated pin height? Anybody make one? Any demand? Its like $1000 or $2000 buy in for custom pistons aint it? Or are custom rods cheaper?
Cylinder spacers are ...
Also can I just change the clutch pushrod from a newer motor & add the bearing? On an 86 of course
Short Rod Piston with long rod compensated pin height?
- Roostius_Maximus
- Site Admin
- Posts: 4641
- Joined: November 16th, 2007, 3:24 pm
- Location: Mt Nebo, Manitoba, Canada
- Contact:
the bearing will not fit behind the pressure plate of a narrow basket setup, likely the only reason they went to the wide one.
no to the pin height, too much skirt thrust if its moved.
no to the pin height, too much skirt thrust if its moved.
http://www.youtube.com/user/500bigbore
My CR500 Tech Reference... http://sdrv.ms/1a0CIiz
MRE Components... http://sdrv.ms/1bs2zhd
My CR500 Tech Reference... http://sdrv.ms/1a0CIiz
MRE Components... http://sdrv.ms/1bs2zhd