Case bushing needed (1986)
Case bushing needed (1986)
Like title said, I need a case bushing where the swingarm goes. This is to fit in a 1986 case.
Thank you
Thank you
- Roostius_Maximus
- Site Admin
- Posts: 4641
- Joined: November 16th, 2007, 3:24 pm
- Location: Mt Nebo, Manitoba, Canada
- Contact:
You're looking for one stock to an 86, not to update it larger correct?
I'd have 1986 ones
I'd have 1986 ones
http://www.youtube.com/user/500bigbore
My CR500 Tech Reference... http://sdrv.ms/1a0CIiz
MRE Components... http://sdrv.ms/1bs2zhd
My CR500 Tech Reference... http://sdrv.ms/1a0CIiz
MRE Components... http://sdrv.ms/1bs2zhd
Actually it is to enlarge it. Is the OD of the earlier ones larger? I was debating on boring the bushing or the casing...
Also, Yamaha is selling the bushing unlike Honda or the other make, I found that the pre-2001 YZ250 uses 17mm swingarm pivot bolt, but I don't know the other dimension on the bushing, may be a good start too...
Also, Yamaha is selling the bushing unlike Honda or the other make, I found that the pre-2001 YZ250 uses 17mm swingarm pivot bolt, but I don't know the other dimension on the bushing, may be a good start too...
- Roostius_Maximus
- Site Admin
- Posts: 4641
- Joined: November 16th, 2007, 3:24 pm
- Location: Mt Nebo, Manitoba, Canada
- Contact:
the 1989+ bushing will not fit in the case without boring the hole first, the older bushing is too thin to bore and expect it to not shatter.
http://www.youtube.com/user/500bigbore
My CR500 Tech Reference... http://sdrv.ms/1a0CIiz
MRE Components... http://sdrv.ms/1bs2zhd
My CR500 Tech Reference... http://sdrv.ms/1a0CIiz
MRE Components... http://sdrv.ms/1bs2zhd
- Roostius_Maximus
- Site Admin
- Posts: 4641
- Joined: November 16th, 2007, 3:24 pm
- Location: Mt Nebo, Manitoba, Canada
- Contact:
That'd be great
http://www.youtube.com/user/500bigbore
My CR500 Tech Reference... http://sdrv.ms/1a0CIiz
MRE Components... http://sdrv.ms/1bs2zhd
My CR500 Tech Reference... http://sdrv.ms/1a0CIiz
MRE Components... http://sdrv.ms/1bs2zhd
-
- Posts: 4
- Joined: January 28th, 2013, 7:20 pm
Update here:Roostius_Maximus wrote:That'd be great
http://bannedcr500riders.com/board/view ... 459#141459