GEN 2 250/500 RADIATOR ?

Building Tips, Suspension Set Ups, Conversion Parts .... Build to your Heart's Content!
Post Reply
02widowmaker
Posts: 1
Joined: December 18th, 2012, 1:09 pm
Last active:
Location: DELTA pA

GEN 2 250/500 RADIATOR ?

Post by 02widowmaker »

Hey guys new on here. I am in the middle of a gen 2 build and have some questions on radiators for this build. Are you reusing the 250 rads? Right rad bottom crossover is close. Frame is all done I"ll post pics soon.
TWO STROKES ARE FOR MEN, FOUR STROKES ARE FOR LAZY MEN
Top
User avatar
freeride588
Posts: 418
Joined: November 20th, 2010, 3:51 pm
Last active:
Location: San Diego

Post by freeride588 »

Welcome man you should head over to the introduction section and say hello. To answer your question you use the 250 radiators. Some of the outlets you have to modify. Some people cut them off and weld new ones on but i just carefully heated the bends ans stuck a wood dowel in the hole and bent them slowly without adding to much heat as the aluminum is super thin.
Kevin
Top
User avatar
hoofarted
Posts: 2628
Joined: July 2nd, 2007, 8:48 am
Last active:
Location: Rancho Cucamonga, CA

Post by hoofarted »

Its good-n-tight, but it'll fit.

Look up my build.
The CR500 is an acquired taste. If you don't like it, acquire some taste...

Image
Top
Post Reply

Return to “A/F's Only.... Talk About Your Beer Can, Right Friggin HERE!”