was bord today, so thought i might as well make my head stay. this was the first time i have used my milling machine and it turned out to be a little harder then i had imagined. did not turn out as i had hoped, but with some sanding she might look a bit better!
if everything seems to be under control, ur not going fast enuf!
tacoma69 wrote:was bord today, so thought i might as well make my head stay. this was the first time i have used my milling machine and it turned out to be a little harder then i had imagined. did not turn out as i had hoped, but with some sanding she might look a bit better!
started to mock everything up so i could get my pipe and muffler to fit and get my brackets all made so i could take it back to the welders to finish up.
rear pipe mount
whipped up some coil mounts
if everything seems to be under control, ur not going fast enuf!
thanx bob! i wish i had another muffler to use the pipe off it. i like what you did, nice and clean. i dont even know were to find SS pipe that would work.........
if everything seems to be under control, ur not going fast enuf!
today i was looking for the best spot to put my coil, and was thinking about welding it behind the headstay. it would have been a hard spot to get in there to weld it, so i came up with a diffrend approach. i know its not the prettiest. all i can say is thank
god you wont be able to see it!!!
if everything seems to be under control, ur not going fast enuf!
hey thats a good spot for stuff, thats where my cdi lives as the wires are to short to reach behind the number plate. keep the ideas flowing, thats what makes these projects fun
homenf wrote:
I think it may look better with less holes in it. I guess if you are worried about the weight not much else you could do.
The build is lookin good!
yes, that was the reason i drilled holes in it, to lighten it up a bit!
if everything seems to be under control, ur not going fast enuf!
[/img]
ok, its been a long summer and time to finish off my bike. i got this piece of pipe from burns stainless to make the section from my pipe to the muffler.
if everything seems to be under control, ur not going fast enuf!
i really hope those case bushings arent aluminum, hard to tell from the pic
the 450 will have less power and will be harder to start, and will be heavier, but to make up for it it will require more maintenance.
4stroke=dead fish
went to take some pics today and my camera died!!! GGRrr..... found out there was a recall on it and sent it away today. so no pics for a bit. and yes my bushing are steel.
if everything seems to be under control, ur not going fast enuf!