Ok I am measuring for my swingarm spacers , and it's not adding up, are the spacers supposed to touch both the frame rail and the motor bushing? , if so the measurements I get are inside frame rail to motor bushing Left 61.44mm and right 65.18mm , I plan on turning them myself but how come my measurements are so big??? , on a side note can anybody tell me the ID and OD of the stock Honda bushings?
Thanks Rick
Swingarm spacer help
What frame are you putting the 500 engine into.
If it is a Gen 3 or later you need a 54mm bush on the left and a 59mm on the right.
If you are putting the engine into a 02-07 CR125 frame you already have the correct spacers, no need to make anything.
There is no need to turn them up when you can buy them straight from Honda.
If it is a Gen 3 or later you need a 54mm bush on the left and a 59mm on the right.
If you are putting the engine into a 02-07 CR125 frame you already have the correct spacers, no need to make anything.
There is no need to turn them up when you can buy them straight from Honda.
Jack Schitt
DIE FIRST, worry about it later!
DON'T talk about it, Just DO IT!
When in doubt, GO FLAT OUT!
2001 CR500R1 - SOLD
2007 CR250R7 - SOLD
Wife and Daughter - Left Aug 17 - 2010
Jack Schitt - ??????????????
DIE FIRST, worry about it later!
DON'T talk about it, Just DO IT!
When in doubt, GO FLAT OUT!
2001 CR500R1 - SOLD
2007 CR250R7 - SOLD
Wife and Daughter - Left Aug 17 - 2010
Jack Schitt - ??????????????
