definition of acceleration

Is your kid Student Of The Month? Beat up Student Of The Month? Lets hear all about it!
Post Reply
User avatar
NightBiker07
Posts: 1942
Joined: April 16th, 2008, 8:59 pm
Last active:
Location: USA

definition of acceleration

Post by NightBiker07 »

'DEFINITION OF ACCELERATION' (courtesy of Performance Techniques):

One top fuel dragster 500 cubic inch Hemi engine makes more horsepower than the first 4 rows of stock cars at the Daytona 500.

It takes just 15/100ths of a second for all 6,000+ horsepower of an NHRA Top Fuel dragster engine to reach the rear wheels.

Under full throttle, a dragster engine consumes 1-1/2 gallons of nitro methane per second; a fully loaded 747 consumes jet fuel at the same
rate with 25% less energy being produced.

A stock Dodge Hemi V8 engine cannot produce enough power to drive the dragster's supercharger.

With 3,000 CFM of air being rammed in by the supercharger on overdrive, the fuel mixture is compressed into a near-solid form before ignition.

Cylinders run on the verge of hydraulic lock at full throttle.

At the stoichiometric (stoichiometry: methodology and technology by which quantities of reactants and products in chemical reactions are determined) 1.7:1 air/fuel mixture of nitro methane, the flame front temperature measures 7,050 deg F.

Nitro methane burns yellow. The spectacular white flame seen above the stacks at night is raw burning hydrogen, dissociated from atmospheric water vapor by the searing exhaust gases.

Dual magnetos supply 44 amps to each spark plug. This is the output of an arc welder in each cylinder.

Spark plug electrodes are totally consumed during a pass. After halfway, the engine is dieseling from compression, plus the glow of exhaust valves at 1,400deg F. The engine can only be shut down by cutting the fuel flow.

If spark momentarily fails early in the run, unburned nitro builds up in the affected cylinders and then explodes with sufficient force to blow cylinder heads off the block in pieces or split the block in half.
In order to exceed 300 mph in 4.5 seconds, dragsters must accelerate an average of over 4G's. In order to reach 200 mph (well before half-track), the launch acceleration approaches 8G's .

Dragsters reach over 300 miles per hour before you have completed reading this sentence

Top fuel engines turn approximately 540 revolutions from light to light! Including the burnout, the engine must only survive 900 revolutions under load .

The redline is actually quite high at 9,500 rpm.

Assuming all the equipment is paid off, the crew is working for free, and for once NOTHING BLOWS UP, each run costs an estimate $1,000.00 per second.

The current top fuel dragster elapsed time record is 4.428 seconds for the quarter mile (11/12/06, Tony Schumacher, at Pomona, CA). The top speed record is 336.15 mph as measured over the last 66' of the run (05/25/05 Tony Schumacher, at Hebron, OH).

Putting all of this into perspective: You are driving the average $140,000 Lingenfelter 'twin-turbo' powered Corvette Z06. Over a mile up the road, a top fuel dragster is staged and ready to launch down a quarter mile strip as you pass. You have the advantage of a flying start. You run the 'Vette hard up through the gears and blast across the starting line and pass the dragster at an honest 200 mph. The 'tree' goes green for both of you at that moment. The dragster launches and starts after you. You keep your foot down hard, but you hear an incredibly brutal whine that sears your eardrums and within 3 seconds, the dragster catches and passes you. He beats you to the finish line, a quarter mile away from where you just passed him. Think about it, from a standing start, the dragster had spotted you 200 mph and not only caught, but nearly blasted you off the road when he passed you within a mere 1,320 foot long race course.

... and that my friend, is ACCELERATION!
2000 CR250, pipe, filter, Vforce

1980 XL80s
1969 Broncco TX-6

Natural selection favors Smart people, so nature selects morons to be slow and dumb for tigers and stuff too eat. But in our modern world there just aren't enough tigers.
User avatar
CR500R7
Posts: 2542
Joined: April 26th, 2009, 3:41 am
Last active:
Location: South Australia
Contact:

Post by CR500R7 »

Now to fit that engine in an AF. :lol:
User avatar
Hellbear
Posts: 2255
Joined: June 13th, 2007, 8:14 pm
Last active:
Location: Richmond Hill, GA

Post by Hellbear »

I want to see Myth Busters or someone do a show about that. I think it would be cool to see.
Image
100hp honda
Posts: 4394
Joined: July 4th, 2007, 6:57 pm
Last active:

Re: definition of acceleration

Post by 100hp honda »

NightBiker07 wrote:'DEFINITION OF ACCELERATION' (courtesy of Performance Techniques):
It takes just 15/100ths of a second for all 6,000+ horsepower of an NHRA Top Fuel dragster engine to reach the rear wheels.
i dont watch drag racing much but last time i did i thought they said the new top fuel cars were around 8,000 hp :?: . i could be wrong though.
User avatar
arleybeer40
Posts: 632
Joined: October 31st, 2007, 11:38 pm
Last active:
Location: rancho cucamonga

Post by arleybeer40 »

Yep! 8,000 horse power outa 500 cubic inches
Brit must be gay because he always says hes gonna have a fag
User avatar
pstoffers
Posts: 1652
Joined: May 31st, 2007, 8:04 pm
Last active:
Location: Oakdale, CA

Post by pstoffers »

NAHA PRO HILLCLIMBER #216
LIVIN THE DREAM!!!

NOTHING BUT GREEN LABEL BLENDZALL!!!

http://sponsorhouse.loopd.com/Members/P ... /Home.aspx
http://www.pro-hillclimbers.org/
Post Reply