my swingarm

dahondaboy · Post by **dahondaboy** » June 13th, 2008, 6:32 am

heres my + 6" swingarm i just got it back from my welder, it is truly a thing of beauty, almost looks factory nearly seamless.

britincali · Post by **britincali** » June 13th, 2008, 3:23 pm

That definatly looks clean

arleybeer40 · Post by **arleybeer40** » June 13th, 2008, 4:19 pm

should of thrown up some more shots of yours brit

dahondaboy · Post by **dahondaboy** » June 13th, 2008, 4:59 pm

i just wish i would have made it a half inch shorter, i didnt measure with me on it when planning it

so with me on it it is 65 1/2" axle to axle. it should be fine if i dont have a picky inspector at the line.

Slomo · Post by **Slomo** » June 13th, 2008, 5:25 pm

Why didn't you make it adjustable?
I always stand up and lift up on my rear fender when they measure.
My 500 is right at 66" with 14/50 gearing.

dahondaboy · Post by **dahondaboy** » June 13th, 2008, 6:23 pm

well it goes from 65-1/2 to 66-1/4 , i had no time and low money so we took two swingarms and made one.

dahondaboy · Post by **dahondaboy** » June 13th, 2008, 6:26 pm

when they measure is it center of axle to center or outside to outside? how does the go- no go stick work? this is the first time i will have to be measured, i always ran open -x before.

BannedCR500Riders.com

my swingarm

my swingarm