Decking a set of '86 cases

All Engine, Clutch, Chains, and Sprockets Stuff Here.
Post Reply
User avatar
kelroy_leon
Posts: 381
Joined: May 26th, 2009, 9:47 pm
Location: Sacramento CA

Decking a set of '86 cases

Post by kelroy_leon »

I have a set of cases that someone marred up a bit trying to get the cyl off. Any recommendations on a source to get them welded up and decked, possibly have new studs installed?


Thanks in advance.
OLD: You don't know what the f--k you're doing.
PREFERRED: I think you could use more training.
Top
User avatar
Roostius_Maximus
Site Admin
Posts: 4641
Joined: November 16th, 2007, 3:24 pm
Location: Mt Nebo, Manitoba, Canada
Contact:
Contact Roostius_Maximus

Post by Roostius_Maximus »

I can do that very easily, fright would be twice the labor :roll:
Top
User avatar
kelroy_leon
Posts: 381
Joined: May 26th, 2009, 9:47 pm
Location: Sacramento CA

Post by kelroy_leon »

I will look into it. Not too many places I can send it here, that I would feel confident with.
OLD: You don't know what the f--k you're doing.
PREFERRED: I think you could use more training.
Top
User avatar
Kuma
Posts: 854
Joined: February 7th, 2010, 8:26 pm
Location: Norco, Cali

Post by Kuma »

Roostie's done lots of work for hoons on both sites and I can't recall ever seeing any complaints about his work.
Gen 2 AF, yes it's a SH, so I can call it an AF Damm it!
Top
User avatar
Roostius_Maximus
Site Admin
Posts: 4641
Joined: November 16th, 2007, 3:24 pm
Location: Mt Nebo, Manitoba, Canada
Contact:
Contact Roostius_Maximus

Post by Roostius_Maximus »

thanks, more of logistics thing I'm certain. Damn Border :roll:
Top
User avatar
Kuma
Posts: 854
Joined: February 7th, 2010, 8:26 pm
Location: Norco, Cali

Post by Kuma »

ya just can't trust them canuks :wink:
Gen 2 AF, yes it's a SH, so I can call it an AF Damm it!
Top
Post Reply

Return to “Drive Tech”