I am starting to dick around with pipe design for my 500 project. I have some software (2 stroke wizard tuned pipe pro 3) that I am going to use for design and then my plan is to draw it up in CAD, print out a template and then get my welder buddy to give it a shot. Sooooo I started mapping out my cylinder and realized that I could very easily get some wrong numbers. While I am all about learning stuff I figured for the sake of a decent pipe and since some of ya'll might know this off the top of your head, I would be better off asking for some of ya'll knowledge
1984 CR500 Cylinder:
bore x stroke: 491x?
length x width of exhasut port
exhaust open period? degrees
main transfer open period? degrees
secondary transfer open period? degrees
rear boost open period? degrees
BTW I know this is kinda asking a lot but I will post the dimensions the software kicks out for ya'll to use/compare/ analyze ect. Thanks guys
![Smile :)](./images/smilies/icon_smile.gif)