Baseline jetting for PWK 40mm

All Engine, Clutch, Chains, and Sprockets Stuff Here.
Post Reply
User avatar
maddog1927
Posts: 313
Joined: April 4th, 2010, 8:10 am
Last active:
Location: Mesa, AZ

Baseline jetting for PWK 40mm

Post by maddog1927 »

Any Ideas on a good starting point for jetting a PWK (38 mm bored to 40) for a stock engine, 90mm bore, PC pipe, sea level.

Currently in the cab is

needle DEJ middle position
Main 178
Pilot 55


Any suggestions would be greatly appriciated
Top
User avatar
1fstdsl
Posts: 2
Joined: October 19th, 2010, 8:55 am
Last active:
Location: Gilbert, AZ

Re: Baseline jetting for PWK 40mm

Post by 1fstdsl »

maddog1927 wrote: Any suggestions would be greatly appriciated
Hmmm...how about a spell checker :D
Top
Post Reply

Return to “Drive Tech”