fcr carb on the cr500?

All Engine, Clutch, Chains, and Sprockets Stuff Here.
Post Reply
r1yfz
Posts: 211
Joined: October 7th, 2009, 6:03 pm
Last active:

fcr carb on the cr500?

Post by r1yfz »

has anyone tried a fcr carb on there cr500? there stock 39mm but can be bored to 44mm

I belive tat they use the same main jets and pilots so should equally the sam to tune...

just looking for some advice
Top
r1yfz
Posts: 211
Joined: October 7th, 2009, 6:03 pm
Last active:

Post by r1yfz »

anyone?
Top
User avatar
redrocket190
Posts: 1229
Joined: September 17th, 2007, 9:07 pm
Last active:
Location: San Clemente, CA

Post by redrocket190 »

There's a reason that FCR carbs are used on four strokes and not two strokes...
Michael Stiles
2007 Honda CR500R-AF
Top
User avatar
AlisoBob
"Hoon-father"
Posts: 15404
Joined: May 31st, 2007, 6:39 pm
Last active:
Location: Aliso Viejo Ca

Post by AlisoBob »

Air boots wont fit, carb's too short, designed for a 4 stroke like Stiles mentioned.... Little improvement in airflow dosent even begin to out weigh the hassles...

The 41mm pwk is a no brainer...
Top
Post Reply

Return to “Drive Tech”