so does anyone sell the diy kits for the gen1 ?

[nickg]

i am looking to do a gen 1 converson, anyone still sell the diy kits?
I searched for info on the pipe, can you make a standard aftermarket pupe for the 91- 500 work? is it just moving the rare mount? also, what is the difference in the earlier (85-88) motrors and the later ones?

[HrcRacing]

Scroll down to the bottom of the page on the link below.

http://bannedcr500riders.com/board/view ... &start=150

If you don't have the pdf file that ShanMan put together or can't find it here on the forums, email me at hrcracing@bellsouth.net and I'll forward it to you.

[robertg]

You can make the standard pipe work no problem. I'm not that familiar with the Gen I, but you might have to modify the rear mount a bit. If you use the old style motor, the coolant hose interferes with the pipe a bit, and I think the intake hits it also. You are better off with an 89+ motor.

[asteroid500]

i can get you all the bits if your in australia

[Roostius_Maximus]

the 85-88 log reed engine hits a 89-01 style fatty for sure, and to sneak a gnarly into a gen4 past it you need a new dent

[AlisoBob]

If you don't have the pdf file that ShanMan put together or can't find it here on the forums, email me at hrcracing@bellsouth.net and I'll forward it to you.

http://bannedcr500riders.com/board/cms_ ... .php?aid=7

[juddy]

Asteroid,where you gettting the front engine mounts from ? I could do with a set.

Cheers

[asteroid500]

Juddy,
my cousin Stuey milled them up for me.
infact he made the bloody lot.



i'll see how much he'll charge to whip up a set.

[juddy]

Ok cool,thanks.They look pretty sweet.

So do you race enduros up around Darwin/Adelaide River ? Done a couple out there about 13 years ago on a 93 CR 500. Even beat AJ,although he was on a KX 100 and he was just a kid ha ha.