you sir are correct. kicker area would need some material removed to allow the lever to rotate properly (cutting a half moon shape should do the trick). remote starter would eliminate all need for a kick lever but would hamper the bikes versatility.
Have you measured the rear engine mount to see if it will fit between the swingarm?
Last edited by CR500R7 on December 7th, 2009, 1:21 am, edited 1 time in total.
Jack Schitt
DIE FIRST, worry about it later!
DON'T talk about it, Just DO IT!
When in doubt, GO FLAT OUT!
2001 CR500R1 - SOLD
2007 CR250R7 - SOLD
Wife and Daughter - Left Aug 17 - 2010
Jack Schitt - ??????????????
The output shaft for the chain drive is on the other side, will all that clear OK? Can you just turn a hub around and drive it in the opposite direction? I cant see why not? I think it would be awesome, I love the old Kater big bores, I have 2
a couple of obsticles, like how that carb is going to suck air thru the shock reservoir and ya, the swingarm deal, nevermind snaking a stock pipe thru the chasis
Roostius_Maximus wrote:a couple of obsticles, like how that carb is going to suck air thru the shock reservoir and ya, the swingarm deal, nevermind snaking a stock pipe thru the chasis
custom pipe and make a custom airbox and rotate the shock so the resevior is on the other side
hey I didnt say that it would be an easy build, to me the kickstarter looks like a deal breaker, if you cut up the frame to accomodate it than it will create a weak point
Jack Schitt
DIE FIRST, worry about it later!
DON'T talk about it, Just DO IT!
When in doubt, GO FLAT OUT!
2001 CR500R1 - SOLD
2007 CR250R7 - SOLD
Wife and Daughter - Left Aug 17 - 2010
Jack Schitt - ??????????????