Hey anyone one here has drawings for a cr250 2001 gen 2 af headstay and swing arm spacer dimention???
it would save me a hole lot of time.....
gen 2 spacers and headstay...
-
- Posts: 14
- Joined: March 13th, 2009, 8:47 pm
- Location: Quebec Canada
I made my own out of 3/16" AL - NOT 6061 BTW. I mocked up a cardboard template, then cut out them out of AL and bent them where it needed - fits quite well and is still holding up for over a year now.
See pix:
I have more build pics - lemme know if u need more.
See pix:
I have more build pics - lemme know if u need more.
The CR500 is an acquired taste. If you don't like it, acquire some taste...
-
- Posts: 14
- Joined: March 13th, 2009, 8:47 pm
- Location: Quebec Canada
nice!!!
good for the headstay i will make my some tomorrow.....
I just need the dimensions of the swing arm spacers..........
I just need the dimensions of the swing arm spacers..........
Re: nice!!!
swing arm spacers are the same as Gen1. IIRC they're both 17mm ID x 4mm and 6mm thick.lazyboy153 wrote:good for the headstay i will make my some tomorrow.....
I just need the dimensions of the swing arm spacers..........
The CR500 is an acquired taste. If you don't like it, acquire some taste...