has anyone used one of these for ali
they work really well the one on the left is 5mm thick and can be used like a planer the one on the right is 2mm thick and flies thu anything
tungsten blade 5" cutting discs
tungsten blade 5" cutting discs
only posties ride 4 stroke hondas
goldfields sheet metal fabrication
98 yzfr1
05 crf 500 race tech goldies
2010 rmz 500af
01 banshee
goldfields sheet metal fabrication
98 yzfr1
05 crf 500 race tech goldies
2010 rmz 500af
01 banshee
Ha - your blades are gay!
Even says so on the pic:
Kidding aside, the one on the right looks like a concrete blade! If you're in doubt, try cutting a piece of scrap stock first! Also, FYI - The stone cutting wheels are known to contaminate the areas to be welded.
Even says so on the pic:
Kidding aside, the one on the right looks like a concrete blade! If you're in doubt, try cutting a piece of scrap stock first! Also, FYI - The stone cutting wheels are known to contaminate the areas to be welded.
The CR500 is an acquired taste. If you don't like it, acquire some taste...
The FAG bit is bloody funny
Seriously the best thing to do is use something and then you know.
You already have and you like them, so stuff everyone else.
You put it out there for everyone to see and if no one tries them, it is no skin off your nose.
Seriously the best thing to do is use something and then you know.
You already have and you like them, so stuff everyone else.
You put it out there for everyone to see and if no one tries them, it is no skin off your nose.
Jack Schitt
DIE FIRST, worry about it later!
DON'T talk about it, Just DO IT!
When in doubt, GO FLAT OUT!
2001 CR500R1 - SOLD
2007 CR250R7 - SOLD
Wife and Daughter - Left Aug 17 - 2010
Jack Schitt - ??????????????
DIE FIRST, worry about it later!
DON'T talk about it, Just DO IT!
When in doubt, GO FLAT OUT!
2001 CR500R1 - SOLD
2007 CR250R7 - SOLD
Wife and Daughter - Left Aug 17 - 2010
Jack Schitt - ??????????????