wheels ?

[kelroy_leon]

i have a 1990 cr250 and would like to do up some wheels for it. i see motosport has the modular excel sets for cheap. they have them for my 99 cr125. the rear is a small axle like my 90 cr250, but the 99 front is a large axle. i dont see a big issue as far as the rear wheel goes but the front? could i turn down a sleeve to go on over the axle to give it the larger diameter for the bearings to ride on? any ideas ? thanks

[CR500R7]

I don't see why not, thats how I would do it if I was going the same route.
As long as the length was similar to the original axle, if you get what I mean.
Then you could spend a shit load of money and get a different hub, Naa.