nikasil honed with torque plate

All Engine, Clutch, Chains, and Sprockets Stuff Here.
Post Reply
User avatar
AlisoBob
"Hoon-father"
Posts: 15404
Joined: May 31st, 2007, 6:39 pm
Last active:
Location: Aliso Viejo Ca

Post by AlisoBob »

Yup.....
Top
seanmx57
Posts: 728
Joined: January 1st, 2009, 2:28 pm
Last active:

Post by seanmx57 »

So Roostius is hooking me up with a plate for the top. I have a hard time believing that I need one for the bottom of the cylinder. Maybe if the case deck was warped it could distort the jug, doubt it and it would prolly suck air anyway. He made extra's in case anyone needs a frisbee.
Top
User avatar
Roostius_Maximus
Site Admin
Posts: 4641
Joined: November 16th, 2007, 3:24 pm
Last active:
Location: Mt Nebo, Manitoba, Canada
Contact:
Contact Roostius_Maximus

Post by Roostius_Maximus »

I have 2 plates left, they're ready to ship, PM me for price
They are 6" O.D. 92mm I.D. and .750" thick, If a larger bore is needed i can do it for an additional 5$

Image
Top
Post Reply

Return to “Drive Tech”