Send your stuff here, to companies you can trust!!!!!
iggys-amsoil
Posts: 3602 Joined: June 1st, 2007, 6:09 pmLast active: Location: Just North of March Airfield CA
Post
by iggys-amsoil September 17th, 2008, 5:49 pm
....actually suck. Especailly around the subtanks and the tubes for the hoses.
Finally found the other leak by the upper tube coming out. I don't know what there process is assembling one of these. Obviously low budget. Please don't tell me China.
Trinity Racing mild porting FMF
62 pilot, EGH needle, 172 main
03 Gen III CR250 frame
2013 Dodger Charger 5.7 Hemi
http://www.prisonplanet.com
Your Amsoil Customer #
350882
AlisoBob
"Hoon-father"
Posts: 15405 Joined: May 31st, 2007, 6:39 pmLast active: Location: Aliso Viejo Ca
Post
by AlisoBob September 17th, 2008, 6:24 pm
Running Amsoil coolant?
iggys-amsoil
Posts: 3602 Joined: June 1st, 2007, 6:09 pmLast active: Location: Just North of March Airfield CA
Post
by iggys-amsoil September 18th, 2008, 12:12 pm
I didn't say I was having an over heating problem.
hoofarted
Posts: 2628 Joined: July 2nd, 2007, 8:48 amLast active: Location: Rancho Cucamonga, CA
Post
by hoofarted September 18th, 2008, 12:17 pm
Well you have a point. They're weak especially where the connectors are. Those fittings are barely attached - I'd say they were sweat fit like copper fittings are to one another.
The CR500 is an acquired taste. If you don't like it, acquire some taste...
AlisoBob
"Hoon-father"
Posts: 15405 Joined: May 31st, 2007, 6:39 pmLast active: Location: Aliso Viejo Ca
Post
by AlisoBob September 18th, 2008, 12:17 pm
No, but failed rads are not caused by heat, but by chemical reactions...
teemtrubble
Posts: 2269 Joined: October 11th, 2007, 2:15 pmLast active: Location: simi valley, ca
Post
by teemtrubble September 18th, 2008, 12:20 pm
AlisoBob wrote: No, but failed rads are not caused by heat, but by chemical reactions...three methods...
Crashing ( I fixed it for you Bob )
Mike
Travis
Posts: 753 Joined: June 21st, 2008, 5:21 pmLast active: Location: Somerset, KY
Contact:
Post
by Travis September 18th, 2008, 12:22 pm
AlisoBob wrote: No, but failed rads are not caused by heat, but by chemical reactions...
There Bob I fixed it for you.
Travis
Travis
Posts: 753 Joined: June 21st, 2008, 5:21 pmLast active: Location: Somerset, KY
Contact:
Post
by Travis September 18th, 2008, 12:23 pm
Nice Mike, you beat me to it.
Travis
dannygraves
Posts: 8020 Joined: June 1st, 2007, 2:03 pmLast active: Location: Las Vegas, NV
Post
by dannygraves September 18th, 2008, 12:24 pm
don't forget ghetto A/F conversion hose routing / rad mods
'09 kx450f 4-Poke
Gen-4 trail bike --SOLD--
Gen-3 badass trail/mx bike --SOLD--
Gen-1 built dunes bike --SOLD--
'05 klx110 --SOLD--
'95 pw80
AlisoBob
"Hoon-father"
Posts: 15405 Joined: May 31st, 2007, 6:39 pmLast active: Location: Aliso Viejo Ca
Post
by AlisoBob September 18th, 2008, 12:27 pm
Crashing isnt a failure.
dannygraves
Posts: 8020 Joined: June 1st, 2007, 2:03 pmLast active: Location: Las Vegas, NV
Post
by dannygraves September 18th, 2008, 12:30 pm
sure it is, a failure on the riders part! LOL
'09 kx450f 4-Poke
Gen-4 trail bike --SOLD--
Gen-3 badass trail/mx bike --SOLD--
Gen-1 built dunes bike --SOLD--
'05 klx110 --SOLD--
'95 pw80
Travis
Posts: 753 Joined: June 21st, 2008, 5:21 pmLast active: Location: Somerset, KY
Contact:
Post
by Travis September 18th, 2008, 12:31 pm
It is a failure to stay upright. Which often causes Rad failure. Dual Failure
Travis
hoofarted
Posts: 2628 Joined: July 2nd, 2007, 8:48 amLast active: Location: Rancho Cucamonga, CA
Post
by hoofarted September 18th, 2008, 12:45 pm
The CR500 is an acquired taste. If you don't like it, acquire some taste...
hoofarted
Posts: 2628 Joined: July 2nd, 2007, 8:48 amLast active: Location: Rancho Cucamonga, CA
Post
by hoofarted September 18th, 2008, 12:47 pm
oh and one more because I thought it was funny:
The CR500 is an acquired taste. If you don't like it, acquire some taste...
dannygraves
Posts: 8020 Joined: June 1st, 2007, 2:03 pmLast active: Location: Las Vegas, NV
Post
by dannygraves September 18th, 2008, 1:01 pm
hoofarted wrote: oh and one more because I thought it was funny:
OMG, that one brought me to tears!
'09 kx450f 4-Poke
Gen-4 trail bike --SOLD--
Gen-3 badass trail/mx bike --SOLD--
Gen-1 built dunes bike --SOLD--
'05 klx110 --SOLD--
'95 pw80
lewisclan
PVT. 1st Class
Posts: 4804 Joined: June 1st, 2007, 3:34 pmLast active: Location: Yucca Valley CA
Post
by lewisclan September 18th, 2008, 1:04 pm
that is funny
"the game of life of is not so much in holding a good hand as playing a poor hand well"
AlisoBob
"Hoon-father"
Posts: 15405 Joined: May 31st, 2007, 6:39 pmLast active: Location: Aliso Viejo Ca
Post
by AlisoBob September 18th, 2008, 1:17 pm
WTF isnt this in the tech section anyways?
dannygraves
Posts: 8020 Joined: June 1st, 2007, 2:03 pmLast active: Location: Las Vegas, NV
Post
by dannygraves September 18th, 2008, 1:27 pm
oh come on, you know the kids with the crazy yellow lab is hillarious!
'09 kx450f 4-Poke
Gen-4 trail bike --SOLD--
Gen-3 badass trail/mx bike --SOLD--
Gen-1 built dunes bike --SOLD--
'05 klx110 --SOLD--
'95 pw80
hoofarted
Posts: 2628 Joined: July 2nd, 2007, 8:48 amLast active: Location: Rancho Cucamonga, CA
Post
by hoofarted September 18th, 2008, 1:27 pm
yeah, but I saw an opportunity...and it got derailed.
ok - back to tech...
The CR500 is an acquired taste. If you don't like it, acquire some taste...
iggys-amsoil
Posts: 3602 Joined: June 1st, 2007, 6:09 pmLast active: Location: Just North of March Airfield CA
Post
by iggys-amsoil September 18th, 2008, 6:24 pm
AlisoBob wrote: WTF isnt this in the tech section anyways?
Because I don't Approve of the vendors/OEM quality on this.
And Ya Amsoil coolant.
Also to note, I picked up a new one today, Gee how come the tanks have welds on them now.
Now if they just did the tubes coming out it would top notch.
TT I just won the right hand on ebay so I'll send it your way when it gets here.
http://cgi.ebay.com/ebaymotors/ws/eBayI ... 0292653122
AlisoBob
"Hoon-father"
Posts: 15405 Joined: May 31st, 2007, 6:39 pmLast active: Location: Aliso Viejo Ca
Post
by AlisoBob September 18th, 2008, 8:32 pm
iggys-amsoil wrote: AlisoBob wrote: WTF isnt this in the tech section anyways?
Because I don't Approve of the vendors/OEM quality on this.
Thats not the purpose of this area.....
iggys-amsoil
Posts: 3602 Joined: June 1st, 2007, 6:09 pmLast active: Location: Just North of March Airfield CA
Post
by iggys-amsoil September 18th, 2008, 9:48 pm
Ok then,..........
Finally found the other leak by the upper tube coming out. I don't know what there process is assembling one of these. Obviously low budget. Please don't tell me China. 
"the game of life of is not so much in holding a good hand as playing a poor hand well"
Now if they just did the tubes coming out it would top notch. 