All Engine, Clutch, Chains, and Sprockets Stuff Here.
100hp honda
Posts: 4394 Joined: July 4th, 2007, 6:57 pm Last active:
Post
by 100hp honda » July 19th, 2008, 7:29 am
lewisclan wrote: I was trying to fire it on gas yester day it poped once right off the bat then nothing after further investagation I pulled the pipe and it had about 1-cup of gas in her so .......
ill put the right fule init and see if I get more than a pop before it floods
its gonna be hard to lite it on gas with that carb, its dumping in twice the fuel
. it should run for a short period on gas for purging purposes- lite it on meth then plumb in a small container of 20:1-28:1 benol and c12 and run through the motor until it loads up and dies. i know some good threads about how to read the plug for meth so you dont burn a hole in the piston. if you search the web theres more info how to read the plug, which isnt the same as gasoline
http://forums.atvdragracers.com/index.p ... 0&start=20
AlisoBob
"Hoon-father"
Posts: 15404 Joined: May 31st, 2007, 6:39 pm Last active:
Location: Aliso Viejo Ca
Post
by AlisoBob » July 19th, 2008, 9:45 am
Is the fuel solenoid passing fuel?
How do you get a cup of fuel in a carburetored motor? Not from kicking...
100hp honda
Posts: 4394 Joined: July 4th, 2007, 6:57 pm Last active:
Post
by 100hp honda » July 19th, 2008, 10:29 am
what plug you end up putting in there lewisclan ? M1 alky or what kind ? what needle did packard put in there for you ?
teemtrubble
Posts: 2269 Joined: October 11th, 2007, 2:15 pm Last active:
Location: simi valley, ca
Post
by teemtrubble » July 19th, 2008, 10:44 am
AlisoBob wrote: Is the fuel solenoid passing fuel?
How do you get a cup of fuel in a carburetored motor? Not from kicking...
It has to be a solenoid issue I would think.
Mike
teem trubble works CR500
(Gen 3 125+CR500 motor)
If I wanted a Yamaha I would have bought a piano!
britincali
Posts: 8207 Joined: May 31st, 2007, 7:10 pm Last active:
Location: Barstow, CA
Post
by britincali » July 19th, 2008, 10:54 am
teemtrubble wrote: AlisoBob wrote: Is the fuel solenoid passing fuel?
How do you get a cup of fuel in a carburetored motor? Not from kicking...
It has to be a solenoid issue I would think.
I don't know those alky jets are HUGE and I know from experience you can get at least 1/2 a cup of fuel in the bottom of the motor from kicking.... (see the fuel puddle?)
Coolness list by 90cr500guy
Bob's = 50/50
Cepek = cool
Solidbro = cool
Brit = loser
Stoffer = 1 up from Brit
MFDB = cool
Danny = ok
lewisclan
PVT. 1st Class
Posts: 4804 Joined: June 1st, 2007, 3:34 pm Last active:
Location: Yucca Valley CA
Post
by lewisclan » July 19th, 2008, 4:38 pm
it was from bump rolling the motor with the carb closed using the electric starter . after I cleaned it all out I used meth and I wAS STILL ROLLING THE THING OVER ........
i REACHED OVER AND OPENED THE CARB AND BANG,
SHE FIRED .
"the game of life of is not so much in holding a good hand as playing a poor hand well"
lewisclan
PVT. 1st Class
Posts: 4804 Joined: June 1st, 2007, 3:34 pm Last active:
Location: Yucca Valley CA
Post
by lewisclan » July 19th, 2008, 4:39 pm
iLL GET A FEW HEAT CYCLES IN ON SUNDAY
"the game of life of is not so much in holding a good hand as playing a poor hand well"
teemtrubble
Posts: 2269 Joined: October 11th, 2007, 2:15 pm Last active:
Location: simi valley, ca
Post
by teemtrubble » July 19th, 2008, 5:35 pm
Yeeeeeaaaaahhhhh!!!!!
Mike
teem trubble works CR500
(Gen 3 125+CR500 motor)
If I wanted a Yamaha I would have bought a piano!
lewisclan
PVT. 1st Class
Posts: 4804 Joined: June 1st, 2007, 3:34 pm Last active:
Location: Yucca Valley CA
Post
by lewisclan » July 19th, 2008, 7:11 pm
100hp honda wrote: what plug you end up putting in there lewisclan ? M1 alky or what kind ? what needle did packard put in there for you ?
m-5 alky., not sure what Dennis put in there
"the game of life of is not so much in holding a good hand as playing a poor hand well"
lewisclan
PVT. 1st Class
Posts: 4804 Joined: June 1st, 2007, 3:34 pm Last active:
Location: Yucca Valley CA
Post
by lewisclan » July 19th, 2008, 7:12 pm
br8egv plug
"the game of life of is not so much in holding a good hand as playing a poor hand well"
M.F.D.B.
Posts: 2960 Joined: June 1st, 2007, 11:27 am Last active:
Location: Sin City
Post
by M.F.D.B. » July 19th, 2008, 10:40 pm
Did she give you "tears of joy"??
Faster then Speedy Gonzalez, slower then the Road Runner!!! MEEP MEEP
2002 CR80
1999 Cr500
2003 CR250R
2005 CRF250R
2006 YZ450F
2005 CBR1000RR
1997 Banshee
teemtrubble
Posts: 2269 Joined: October 11th, 2007, 2:15 pm Last active:
Location: simi valley, ca
Post
by teemtrubble » July 19th, 2008, 11:22 pm
Jay had a wet sticky spot in his jeans! hahahahaha
Mike
teem trubble works CR500
(Gen 3 125+CR500 motor)
If I wanted a Yamaha I would have bought a piano!
M.F.D.B.
Posts: 2960 Joined: June 1st, 2007, 11:27 am Last active:
Location: Sin City
Post
by M.F.D.B. » July 19th, 2008, 11:41 pm
My dad and I were in the pits checking out an alky funny car. The crew came out and asked everyone to step WAY back as they were about to light it. So all the smart people boned out and the noobs all stepped in closer to fill the void. So on went the gas masks by the crew and they lit her up.
Result??
50 people running away as fast as they could with tears running down their faces!! HAHAHAHAHA
Pain makes the brain remember...
Faster then Speedy Gonzalez, slower then the Road Runner!!! MEEP MEEP
2002 CR80
1999 Cr500
2003 CR250R
2005 CRF250R
2006 YZ450F
2005 CBR1000RR
1997 Banshee
britincali
Posts: 8207 Joined: May 31st, 2007, 7:10 pm Last active:
Location: Barstow, CA
Post
by britincali » July 20th, 2008, 9:44 am
That aint alky thats nitro methane
Coolness list by 90cr500guy
Bob's = 50/50
Cepek = cool
Solidbro = cool
Brit = loser
Stoffer = 1 up from Brit
MFDB = cool
Danny = ok
dannygraves
Posts: 8020 Joined: June 1st, 2007, 2:03 pm Last active:
Location: Las Vegas, NV
Post
by dannygraves » July 20th, 2008, 9:59 am
britincali wrote: That aint alky thats nitro methane
thats some stinky stuff!
'09 kx450f 4-Poke
Gen-4 trail bike --SOLD--
Gen-3 badass trail/mx bike --SOLD--
Gen-1 built dunes bike --SOLD--
'05 klx110 --SOLD--
'95 pw80
AlisoBob
"Hoon-father"
Posts: 15404 Joined: May 31st, 2007, 6:39 pm Last active:
Location: Aliso Viejo Ca
Post
by AlisoBob » July 20th, 2008, 11:49 am
I stand right there......... Taking it all in....
pstoffers
Posts: 1652 Joined: May 31st, 2007, 8:04 pm Last active:
Location: Oakdale, CA
Post
by pstoffers » July 20th, 2008, 11:55 am
AlisoBob wrote: I stand right there......... Taking it all in....
YOU SHIT TOO.....
M.F.D.B.
Posts: 2960 Joined: June 1st, 2007, 11:27 am Last active:
Location: Sin City
Post
by M.F.D.B. » July 20th, 2008, 12:17 pm
britincali wrote: That aint alky thats nitro methane
That stuff is nastier but this wasnt a Top Fuel Funny Car, it was an Alky car...
The R/C cars/planes/helis/etc. run on Nitro and those little things can clear a room by themselves!!
Faster then Speedy Gonzalez, slower then the Road Runner!!! MEEP MEEP
2002 CR80
1999 Cr500
2003 CR250R
2005 CRF250R
2006 YZ450F
2005 CBR1000RR
1997 Banshee
lewisclan
PVT. 1st Class
Posts: 4804 Joined: June 1st, 2007, 3:34 pm Last active:
Location: Yucca Valley CA
Post
by lewisclan » July 20th, 2008, 12:55 pm
well I have a vacumme leak some where and I have way to much fuel runing through the carb.
I am not sure it I will be bringing it to pismo
"the game of life of is not so much in holding a good hand as playing a poor hand well"
M.F.D.B.
Posts: 2960 Joined: June 1st, 2007, 11:27 am Last active:
Location: Sin City
Post
by M.F.D.B. » July 20th, 2008, 12:57 pm
lewisclan wrote: well I have a vacumme leak some where and I have way to much fuel runing through the carb.
I am not sure it I will be bringing it to pismo
You got almost a week, DO IT!!
Faster then Speedy Gonzalez, slower then the Road Runner!!! MEEP MEEP
2002 CR80
1999 Cr500
2003 CR250R
2005 CRF250R
2006 YZ450F
2005 CBR1000RR
1997 Banshee
britincali
Posts: 8207 Joined: May 31st, 2007, 7:10 pm Last active:
Location: Barstow, CA
Post
by britincali » July 20th, 2008, 12:59 pm
lewisclan wrote:
I am not sure it I will be bringing it to pismo
Running or not bring it anyway.
Coolness list by 90cr500guy
Bob's = 50/50
Cepek = cool
Solidbro = cool
Brit = loser
Stoffer = 1 up from Brit
MFDB = cool
Danny = ok
dannygraves
Posts: 8020 Joined: June 1st, 2007, 2:03 pm Last active:
Location: Las Vegas, NV
Post
by dannygraves » July 20th, 2008, 1:59 pm
DUDE JAY! MAKE IT HAPPEN!
'09 kx450f 4-Poke
Gen-4 trail bike --SOLD--
Gen-3 badass trail/mx bike --SOLD--
Gen-1 built dunes bike --SOLD--
'05 klx110 --SOLD--
'95 pw80
sabreguy
Posts: 2915 Joined: June 1st, 2007, 5:07 pm Last active:
Location: Middle of the Freakin Mojave Desert!
Post
by sabreguy » July 20th, 2008, 2:17 pm
britincali wrote: lewisclan wrote:
I am not sure it I will be bringing it to pismo
Running or not bring it anyway.
X2
88CR500
ROOST ON PEOPLE!!!
teemtrubble
Posts: 2269 Joined: October 11th, 2007, 2:15 pm Last active:
Location: simi valley, ca
Post
by teemtrubble » July 20th, 2008, 2:39 pm
You guy's are funny...
Mike
teem trubble works CR500
(Gen 3 125+CR500 motor)
If I wanted a Yamaha I would have bought a piano!
100hp honda
Posts: 4394 Joined: July 4th, 2007, 6:57 pm Last active:
Post
by 100hp honda » July 20th, 2008, 6:59 pm
pstoffers wrote: AlisoBob wrote: I stand right there......... Taking it all in....
YOU SHIT TOO.....
30sec and bob would be in the corner holding his ears and crying