Okay, here's mine, nearly done..NOW FOR SALE (FINISHED)
Okay, here's mine, nearly done..NOW FOR SALE (FINISHED)
Lookin good??
Well I think it is
Engine now built and will be in before weekend(baby permitting)
Then it's just a case of doing the small little jobs of getting everything to fit right
BLING
For info..
CRF450 03 with later tank/plastics,Showa forks with radial brembo caliper,Talon.Excel wheels, ohlins rear shock,brembo radial master,pro taper bars,billet triples, crf250 GMX rads 93 cr500 motor with Eric Gorr barrel,rad valve,PWK,billet basket,dirt digger clutch,K&N filter and pro circuit pipe
Well I think it is
Engine now built and will be in before weekend(baby permitting)
Then it's just a case of doing the small little jobs of getting everything to fit right
BLING
For info..
CRF450 03 with later tank/plastics,Showa forks with radial brembo caliper,Talon.Excel wheels, ohlins rear shock,brembo radial master,pro taper bars,billet triples, crf250 GMX rads 93 cr500 motor with Eric Gorr barrel,rad valve,PWK,billet basket,dirt digger clutch,K&N filter and pro circuit pipe
Last edited by Gix on August 26th, 2008, 3:42 pm, edited 1 time in total.
- dannygraves
- Posts: 8020
- Joined: June 1st, 2007, 2:03 pm
- Location: Las Vegas, NV
- teemtrubble
- Posts: 2269
- Joined: October 11th, 2007, 2:15 pm
- Location: simi valley, ca
- britincali
- Posts: 8207
- Joined: May 31st, 2007, 7:10 pm
- Location: Barstow, CA
- dannygraves
- Posts: 8020
- Joined: June 1st, 2007, 2:03 pm
- Location: Las Vegas, NV
-
- Posts: 678
- Joined: February 22nd, 2008, 8:18 pm