Any thoughts on this port job?

All Engine, Clutch, Chains, and Sprockets Stuff Here.
Post Reply
2legit2quit
Posts: 4
Joined: July 8th, 2016, 4:15 pm
Last active:

Any thoughts on this port job?

Post by 2legit2quit »

Image

Bought a cr5 engine recently for an AF project. Took a look inside the intake and exhaust ports and this is what I found. I'm curious if this kind of port work is going to kill my bottom end. It's for a trail bike so I don't want an all top end engine.
Top
2legit2quit
Posts: 4
Joined: July 8th, 2016, 4:15 pm
Last active:

Post by 2legit2quit »

Image


Oh and I know the piston is cracked. This engine is getting a full rebuild so I'm not worried about it.
Top
User avatar
Roostius_Maximus
Site Admin
Posts: 4641
Joined: November 16th, 2007, 3:24 pm
Last active:
Location: Mt Nebo, Manitoba, Canada
Contact:
Contact Roostius_Maximus

Post by Roostius_Maximus »

Hard to tell really. The intake side has the ceilings of the aux ports tapered up which I don't like. The angle from the walls to the piston are done well. Exhaust side is sketchy
Top
User avatar
Sandblaster
Posts: 84
Joined: January 29th, 2015, 10:24 pm
Last active:

Post by Sandblaster »

Send the top end to Roostie... You won't be disappointed...
The four stroke engine: That's one stroke for producing power and three for wearing the engine out.
Top
Post Reply

Return to “Drive Tech”