I need a second (and third) set of wheels for my Gen 1 250.
What bolts up?
I can tell you from personal experience that you can bolt up a 1986 rear wheel with drum brakes to a gen 1 if you use the gen 1 spacers and take off the caliper.
Im guessing almost any rear CR wheel will work with the right spacers in.
What about fronts?
Im thinking 95ish to 01ish should be all the same?
Any body know for sure?
Rim Swapp-ability
Rim Swapp-ability
Yah, I'm from Saskatchetoon!
MRE 02 250/500 conversion, pulse injector, twirp porting, coolhead, MRE ignition, blah blah blah blah... www.millarengines.com
MRE 02 250/500 conversion, pulse injector, twirp porting, coolhead, MRE ignition, blah blah blah blah... www.millarengines.com
-
lewisclan
- PVT. 1st Class
- Posts: 4804
- Joined: June 1st, 2007, 3:34 pm
- Last active:
- Location: Yucca Valley CA
89-01 cr5 wheels will work but you will need to change the rotor the cr250 has a biger rotor. I think I use the cr500 wheel spacers in the gen 1.
I know the front 97 up cr500 are the same not sure how far back . and I think they interchange with the gen 1 ill look this weekend
I know the front 97 up cr500 are the same not sure how far back . and I think they interchange with the gen 1 ill look this weekend
"the game of life of is not so much in holding a good hand as playing a poor hand well"