New Project, where to start
New Project, where to start
I picked up a 2004 CRF 450R complete bike that's stuck in 3rd gear. It runs great but I got it to swap my 96 motor into because I want a modern chassis for the motor and I'm going to sell the crf motor and cr500 chassis to pay for it all. I see the frame kits on ebay for rails and mounts and I see the kit for crf250 which have airbox item.
CRF250 kit
http://www.ebay.com/itm/Complete-alumin ... 0d&vxp=mtr
Frame rail and mounts
http://www.ebay.com/itm/CR500-HONDA-ENG ... a0&vxp=mtr
Airbox
http://www.ebay.com/itm/Airbox-adapter- ... 7f&vxp=mtr
Can I use the Y from this kit to make it easier?
http://www.ebay.com/itm/Complete-alumin ... de&vxp=mtr
CRF250 kit
http://www.ebay.com/itm/Complete-alumin ... 0d&vxp=mtr
Frame rail and mounts
http://www.ebay.com/itm/CR500-HONDA-ENG ... a0&vxp=mtr
Airbox
http://www.ebay.com/itm/Airbox-adapter- ... 7f&vxp=mtr
Can I use the Y from this kit to make it easier?
http://www.ebay.com/itm/Complete-alumin ... de&vxp=mtr
Using Jerc's parts right now for my build -->
http://www.bannedcr500riders.com/board ... hp?t=13183
Recommend his parts 100%
He gives you step by step instructions for the conversion--> http://www.bannedcr500riders.com/board ... hp?t=13204
http://www.bannedcr500riders.com/board ... hp?t=13183
Recommend his parts 100%
He gives you step by step instructions for the conversion--> http://www.bannedcr500riders.com/board ... hp?t=13204
-
- Posts: 52
- Joined: April 27th, 2013, 12:53 am
- Location: QLD, Australia
Jercs,
Here is the link for my build: http://www.bannedcr500riders.com/board/ ... hp?t=13183
Sent you an e-mail the other day for another potential customer
Here is the link for my build: http://www.bannedcr500riders.com/board/ ... hp?t=13183
Sent you an e-mail the other day for another potential customer
I'm back on track. Between dealing with military orders and back injury I just put things on hold till I could figure out a few things. I've finally made the first few cuts and now there's no going back. I'm debating now how I'll be proceeding on the Y section and head stay. I'll post some picture later with progress and thoughts so I can bounce ideas.