[/img]
[/img]
[/img]
[/img]Cradle Bending Jig
-
lambofgod85
- Posts: 52
- Joined: April 27th, 2013, 12:53 am
- Last active:
- Location: QLD, Australia
Cradle Bending Jig
This is a Bending Jig I made at work for forming the new 25x25x3mm Aluminium cradle rails for my Gen3. It does a very good job. If anyone wants any info on the Bending Jig just let me know, happy to help.
[/img]
[/img]
[/img]
[/img]
[/img][/img][/img][/img]-
Roostius_Maximus
- Site Admin
- Posts: 4641
- Joined: November 16th, 2007, 3:24 pm
- Last active:
- Location: Mt Nebo, Manitoba, Canada
- Contact:
Bender
Gorgeous bender! I want one!
Do you anneal the tube?
Do you anneal the tube?
http://www.youtube.com/user/500bigbore
My CR500 Tech Reference... http://sdrv.ms/1a0CIiz
MRE Components... http://sdrv.ms/1bs2zhd
My CR500 Tech Reference... http://sdrv.ms/1a0CIiz
MRE Components... http://sdrv.ms/1bs2zhd
-
lambofgod85
- Posts: 52
- Joined: April 27th, 2013, 12:53 am
- Last active:
- Location: QLD, Australia
Hi Roostius_Maximus. Yeah the jig looks alright . I made it up at work, very simple if you got the gear. I decided to use this type of bender, because of my cradle had many bends in it, which the ram type pipe bender would have restricted this or not even made it possible. The tube was bent without annealing, after bending up the test piece, I got a mate at work (40 years blacksmith experience) to check out the tube out. All good 
.
. I made it up at work, very simple if you got the gear. I decided to use this type of bender, because of my cradle had many bends in it, which the ram type pipe bender would have restricted this or not even made it possible. The tube was bent without annealing, after bending up the test piece, I got a mate at work (40 years blacksmith experience) to check out the tube out. All good .