Page 1 of 1
woods fatbars
Posted: September 20th, 2010, 7:17 pm
by 2strokeforever
looking for 28" fatbars, i need enough room to mount everything without the levers being on an angle, found a few 7/8 but no fatbars
Posted: September 21st, 2010, 4:53 am
by jarnott71
try trailtech .com?
Posted: September 21st, 2010, 10:33 am
by bgraley
yeah but check out trailtech.net if you go to .com you end up at a trailer site. you want lights and dirtbike stuff do to the .net. I havn't checked out what they have yet, just the site it self.
Posted: September 21st, 2010, 5:44 pm
by Gmbond
Some guys swear by using mini high bars (yz80 bend seems to be a fave). As the center section is tighter radius and the straight parts are longer to give more room for controls.
Posted: September 21st, 2010, 5:48 pm
by 2strokeforever
Some guys swear by using mini high bars (yz80 bend seems to be a fave). As the center section is tighter radius and the straight parts are longer to give more room for controls.
thats what i was going for but once i get a scotts sub mount theyll be way too high
Posted: December 4th, 2010, 8:55 pm
by 2strokeforever
well i got the tusk race low bend, and cut them 7/8 on each end, the barkbuster mounts barely work now but that still works
so far there good, havent bent yet and only cost $40