Fastest build yet-90 cr500
Posted: May 30th, 2010, 10:13 pm
So as usual I waited too long to build my bike for the trip to the dunes. I had the bare frame painted, and in 4 long nights, assembled the engine with a new crank and top end, stainless hardware kit-thanks to Roosty (who I still owe for that and the trans bearings)
Rebuilt the 01 forks and rear susp. bearings. 01 shock, desert tank, old school FMF Fatty, 12 paddle skat trak. It's the perfect recipe for a swet ride in the sand.
Engine is all fresh-millar's bolt kit is sweet looking and makes 3HP
The frame paint was a last minute decision and the paint barely had time to dry
Engine and cooling system in and tight
Topar racing case savers are a nice piece
Almost there, about 40 beers into it-up till 4am 4 nights in a row
Shake down run at the place i've been riding since I was a kid-not too sure why the tire looks like it's moving
Rebuilt the 01 forks and rear susp. bearings. 01 shock, desert tank, old school FMF Fatty, 12 paddle skat trak. It's the perfect recipe for a swet ride in the sand.
Engine is all fresh-millar's bolt kit is sweet looking and makes 3HP
The frame paint was a last minute decision and the paint barely had time to dry
Engine and cooling system in and tight
Topar racing case savers are a nice piece
Almost there, about 40 beers into it-up till 4am 4 nights in a row
Shake down run at the place i've been riding since I was a kid-not too sure why the tire looks like it's moving