Silverwood , Tomorrow 5-20
Posted: May 19th, 2010, 10:08 am
Me
Mad Dog
?????
Mad Dog
?????
BannedCR500Riders.com
Addressing the survival of the legendary CR500!
https://www.bannedcr500riders.com/
Silverwood , Tomorrow 5-20
Page 1 of 1
Posted: May 19th, 2010, 10:13 am
Ahh i wish i could go. i have work till next wed and then i am off for the summer. do you want to ride next week too?
Posted: May 19th, 2010, 1:08 pm
Damn! If I didn't have a Dr. Appointment tomorrow I would be there.
Posted: May 19th, 2010, 6:17 pm
Maybe next time, I played hooky on Monday for a charity golf tournament put on by San Manuel casino, they sure had the money to put on quite a spread!!!
Posted: May 19th, 2010, 10:38 pm
Love to but Cepek and I are headed up to the SAC to the Outdoors at Hangtown. 
Posted: May 20th, 2010, 8:33 am
Mad Dog was having Magura trouble...
Mike, follow these bleed instructions....
http://bannedcr500riders.com/board/viewtopic.php?t=249
Mike, follow these bleed instructions....
http://bannedcr500riders.com/board/viewtopic.php?t=249
Posted: May 20th, 2010, 2:26 pm
It's working now. MSM fixed it up and walked me through it.
Still doesn't feel like it's disengaging completely.
Not sure about these Magura's, cost me a day of riding.
Never had problem with a cable.
Still doesn't feel like it's disengaging completely.
Not sure about these Magura's, cost me a day of riding.
Never had problem with a cable.
Posted: May 20th, 2010, 2:30 pm
I need to run an extra spacer under my slave cylinder for it to disengage properly, I drilled out a 1/4" 6mm socket and used that under the magura spacer to move the slave up and give it some more pull.
Posted: May 20th, 2010, 3:43 pm
Get the air out, pikey....britincali wrote:I need to run an extra spacer under my slave cylinder for it to disengage properly, I drilled out a 1/4" 6mm socket and used that under the magura spacer to move the slave up and give it some more pull.
Posted: May 20th, 2010, 3:50 pm
No air.
It bottoms out on the stroke and wont pull the lever high enough.
It bottoms out on the stroke and wont pull the lever high enough.
Posted: May 27th, 2010, 9:35 am
My new Magura worked just fine out of the box.
The only adjustment is the clutch lever thumb screw.
I only had mine on for a few rides now, and works great. I did have to adjust mine a few times while riding but that was probably due to the engine warming up.
I figure when the clutch is worn it would act that way.
Al
The only adjustment is the clutch lever thumb screw.
I only had mine on for a few rides now, and works great. I did have to adjust mine a few times while riding but that was probably due to the engine warming up.
I figure when the clutch is worn it would act that way.
Al
Posted: May 27th, 2010, 9:44 am
Posted: May 27th, 2010, 4:57 pm
I laughed about this place too after moving to LA from Spokane.
as a kid, we hangared our Cessna 182 at silverwood when it was called Henley Airdrome.