Override Trans...
Posted: March 7th, 2010, 10:51 pm
Ok, I know what they do, but I have been unable to locate a tech article or tutorial on HOW they mechanically do it. Anyone?
BannedCR500Riders.com
Addressing the survival of the legendary CR500!
https://www.bannedcr500riders.com/
Override Trans...
Page 1 of 1
Posted: March 7th, 2010, 10:59 pm
X 2! Please
Posted: March 8th, 2010, 12:22 am
do what 
Posted: March 8th, 2010, 6:50 am
I have one in my Meth bike and in the 500 you can only cut the 1st 3 gears 4th & 5th run the other direction so I am told by the guy that built mine Port Majic , he builds alot of the sand drag stuff for the pros ATV.
the tranny can shift through the gears with out leting off the throttal under a full load just hold it open and bang away. only up to 3rd gear 4 & 5 you eather need to pull the clutch in or use an electric cut out switch to unload the motor to shift without using the clutch.
I dont remember what the tranny cost me but it wasent to bad, the electric shifter was like $650 or around there I still havent opened the box its sitting on a shelf in the shop.
to answer your question Ruddy showed me what he did and whats needed to cut but it was so long ago I dont remember
you can not have back pressure on the tranny with a override like transmission brakeing because it will bend the shifting fork
which I probably did out at pismo slaming it into gear when it ran away on me
the tranny can shift through the gears with out leting off the throttal under a full load just hold it open and bang away. only up to 3rd gear 4 & 5 you eather need to pull the clutch in or use an electric cut out switch to unload the motor to shift without using the clutch.
I dont remember what the tranny cost me but it wasent to bad, the electric shifter was like $650 or around there I still havent opened the box its sitting on a shelf in the shop.
to answer your question Ruddy showed me what he did and whats needed to cut but it was so long ago I dont remember
you can not have back pressure on the tranny with a override like transmission brakeing because it will bend the shifting fork
which I probably did out at pismo slaming it into gear when it ran away on me
Posted: March 8th, 2010, 8:04 am
As long as you didnt break the gears, you should be ok with just a few shift forks. Those are a lot cheaper than cases!
Posted: March 8th, 2010, 8:43 am
Yeah and I think I have a spare tranny boxed up around here somewhere