Page 1 of 1
Swingarm spacer help
Posted: February 3rd, 2010, 9:22 pm
by agent
Ok I am measuring for my swingarm spacers , and it's not adding up, are the spacers supposed to touch both the frame rail and the motor bushing? , if so the measurements I get are inside frame rail to motor bushing Left 61.44mm and right 65.18mm , I plan on turning them myself but how come my measurements are so big??? , on a side note can anybody tell me the ID and OD of the stock Honda bushings?
Thanks Rick
Posted: February 3rd, 2010, 9:58 pm
by agent
Ok I am a dumbass, I think I figured it out... Washers I forgot the Washers. I am an idiot sorry
Rick
Posted: February 3rd, 2010, 10:01 pm
by CR500R7
What frame are you putting the 500 engine into.
If it is a Gen 3 or later you need a 54mm bush on the left and a 59mm on the right.
If you are putting the engine into a 02-07 CR125 frame you already have the correct spacers, no need to make anything.
There is no need to turn them up when you can buy them straight from Honda.
Posted: February 4th, 2010, 5:11 am
by AlisoBob
agent wrote:Ok I am a dumbass, I think I figured it out... Washers I forgot the Washers. I am an idiot sorry
