Page 1 of 1
footpeg measurements needed, coverting gen 3,4 pegs to gen 2
Posted: January 13th, 2010, 8:32 am
by seanmx57
Does anybody have a set of peg brackets off a gen 3 or 4 kicking around. I wanna find out if they bolt up to a gen 2. The #'s from my gen 2 brackets are 1.2" inside to inside where the bolts hold it on the frame. 2.16" same holes outside to outside. Hole diameter is .48 and .42, the .42 is ovaled. The holes are offset in the bracket.
Fastway has discontinued there pegs for gen 2. I'm trying to find out if I can just get a set of gen 3 or 4 brackets bolt em up and be in bizness.
Posted: January 13th, 2010, 2:52 pm
by HrcRacing
Here's the bracket from the right side of my '05 CRF250R frame. Holes measure 1 1/4" OC, are not offset or ovaled.
Posted: January 13th, 2010, 5:52 pm
by 97af
Robert....You know I just had to make a comment about the picture..
Show-off..
Mike...
Posted: January 13th, 2010, 6:49 pm
by seanmx57
looks considerable smaller. weight saving I'm sure. I could weld a stop block into the gen 2 brackets but then I'd have to deal with rust issues.
Posted: January 13th, 2010, 7:29 pm
by caseyracing222
seanmx57 wrote:looks considerable smaller. weight saving I'm sure. I could weld a stop block into the gen 2 brackets but then I'd have to deal with rust issues.
spray paint will fix the rust issue
Posted: January 13th, 2010, 7:34 pm
by HrcRacing
97af wrote:Robert....You know I just had to make a comment about the picture..
Show-off..
Mike...
Yeah, the old girl (Canon 10D) still takes a pretty good picture. Would love to update to the 50D though.
seanmx57 wrote:looks considerable smaller. weight saving I'm sure. I could weld a stop block into the gen 2 brackets but then I'd have to deal with rust issues.
Wish they would have worked for you, shit, I would have given them to you. I'm a picky ass and one of my things on this bike is new peg brackets and pins. It's a mental desease.