Page 1 of 1
buying a torque plate
Posted: December 28th, 2009, 10:53 am
by LOVEMYCR500
Did I see on here somewhere that someone was making and selling torque plates or am I mistaken? If noone is, I will make one, they appear to be about 1/2 thick aluminum plate, does that sound about right ?
Posted: December 28th, 2009, 11:26 am
by robertg
Posted: December 28th, 2009, 11:51 am
by Roostius_Maximus
hey, what kinda rush? i'm out at the moment, have more material arriving tommorrow, could be the end of the week maybee, or if fastkart isnt in a rush for his i could send it
Posted: December 28th, 2009, 1:40 pm
by fastkart
I'm not in any kind of rush. It's a "just in case" thing if I need a cylinder bored local in a hurry rather than sending to Glen.
If I could have mine by the end of April I'd be in good shape.
Posted: December 28th, 2009, 2:01 pm
by Roostius_Maximus
that'll happen
Posted: January 5th, 2010, 9:13 am
by LOVEMYCR500
do you think a 1/2" torque plate is thick enough? I have some 1/2" aluminum plate that I can make one of these out of.
Posted: January 5th, 2010, 9:41 am
by Roostius_Maximus
i make e'm .750, new ones will be .800"