Page 1 of 1
cr250 stator question
Posted: December 2nd, 2009, 9:48 pm
by r1yfz
What years cr250 stator and plate can i run? i will be useing a 1994 fly wheel, and cdi.
is it just 94-96? or can i use a 93?
Posted: December 3rd, 2009, 8:03 am
by r1yfz
found it!
'93-'96 CDI = 30410-KZ3-691
'93-'96 FW+STATOR = 31100-KZ3-891
Re: cr250 stator question
Posted: December 3rd, 2009, 8:11 am
by hoofarted
r1yfz wrote:What years cr250 stator and plate can i run? i will be useing a 1994 fly wheel, and cdi.
is it just 94-96? or can i use a 93?
93-96 same chit - i ended up running a complete 93 and its fine.
Posted: December 3rd, 2009, 8:17 am
by high velocity
Oem and ricky stator are good stators , stay away from eletrosport they are chinese junk.
Posted: December 3rd, 2009, 8:31 am
by r1yfz
hopefully i can find one for cheap.... its the last peice to my puzzled together 250igntion swap
Posted: December 3rd, 2009, 8:34 am
by high velocity
The ricky stator brand new cost me 125 plus 8.00 shipping
Posted: December 3rd, 2009, 8:39 am
by hoofarted
just keep an eye on fleabay. I have a 93 stator that needs to be rewound. Its yours for the cost of shipping if u want it. I got my last stator (OEM) of fleabay for $30. I managed to piece the whole system together for less than $100 including shipping costs. They're out there - just be patient.
Make this guy an offer of $50 and see if he takes it:
http://cgi.ebay.com/ebaymotors/Honda-CR ... ccessories
Posted: December 3rd, 2009, 10:35 am
by r1yfz
anyone know what the cost of rewinding one would be?
Posted: December 3rd, 2009, 10:57 am
by r1yfz
also, is every one useing there stock cr500 coild for the 92-96 ignition upgrade?
Posted: December 3rd, 2009, 10:58 am
by hoofarted
r1yfz wrote:also, is every one useing there stock cr500 coild for the 92-96 ignition upgrade?
Coils are pretty much the same - I am using a 250 coil though because its on my Gen2 AFC and is quite a bit smaller.
Posted: December 3rd, 2009, 11:04 am
by r1yfz
any one try the monster coil?