Page 1 of 1
gen 2 spacers and headstay...
Posted: November 30th, 2009, 6:51 pm
by lazyboy153
Hey anyone one here has drawings for a cr250 2001 gen 2 af headstay and swing arm spacer dimention???
it would save me a hole lot of time.....
Posted: December 1st, 2009, 2:29 am
by alex500
No i do not but i am after the same info..... someone will have em
cheers
Posted: December 1st, 2009, 10:20 am
by hoofarted
I made my own out of 3/16" AL - NOT 6061 BTW. I mocked up a cardboard template, then cut out them out of AL and bent them where it needed - fits quite well and is still holding up for over a year now.
See pix:
I have more build pics - lemme know if u need more.
nice!!!
Posted: December 2nd, 2009, 9:49 pm
by lazyboy153
good for the headstay i will make my some tomorrow.....
I just need the dimensions of the swing arm spacers..........
Re: nice!!!
Posted: December 3rd, 2009, 7:49 am
by hoofarted
lazyboy153 wrote:good for the headstay i will make my some tomorrow.....
I just need the dimensions of the swing arm spacers..........
swing arm spacers are the same as Gen1. IIRC they're both 17mm ID x 4mm and 6mm thick.