BannedCR500Riders.com

Hey guys, ran into a little balls up this avo. was putting the crankcase back together and didnt realise the k&s gasket kit came with two crank case gaskets. i grabbed the green one in my haste and put it together. when i went to get the clutch cover gasket, i realised there was still another grey crank gasket. i read th back of the gasket kit and it said there were one for a 89-91 model and one for 90-01.
i couldn identify which one was the right one?
i measured the thickness and the one is installed was .05 mm thicker. other than that(without ripping the cases apart) i couldn see any difference inbetween them.

so, is it gonna be ok to continue the build with this gas (even though i dont which one)?

the gaskets have no markings on them to id themselves

the gasket i installed was green, the clutch cover gasket and the other crank gasket were a grey ncolour.
i dont particularly want to pull it appart again.

If it was for 87-88 cases it would hang into the crankcase where the jug sits in, trim that and its same as 89-01
as for thickness, theres alot of endplay on the shafts usually, check the thrust on them by not having a sprocket on or a clutch basket, if theres any movement in and out on the shafts then your ok.

music to my ears, looks like ill have her running by tomorrow night then

what gasket set # had both in it?

k&s gasket kit.

stock # 71-1006