Page 1 of 1
Pivot Works or All balls wheel bearing
Posted: September 2nd, 2009, 11:22 pm
by zorak-2
Has anyone ran either Pivot Works or All Balls bearings in their wheels before and if so do know what brand of bearing they are and where they are made ..Just wondering if they are a cheap ass china bearing.
Thanks for the help.
Doug
Posted: September 3rd, 2009, 3:06 am
by thestuz
ive used allballs in my suspension. after a few rides theres a real little bit of play but theyre ok. as for wheel bearings, just make sure theyre packed properly with grease and theyll last.
Posted: September 3rd, 2009, 7:45 pm
by caseyracing222
Ive used pivot works wheel bearings before, they hold up good
Posted: September 21st, 2009, 9:25 pm
by exackery
I tried the all balls rear wheel bearing kit >>> personally I thought it was crap >>> the bearings seemed too "made in china" for me and the seals lasted 2 rides >>> the seal lips tore off both sides road rashing (no mud).
Sorry but I give these the thumbs down (you asked)
Posted: September 22nd, 2009, 5:26 am
by Roostius_Maximus
I've had no trouble with allballs, used linkage kits in my 02 250 ,03 250,88 500, 91 500, wheel bearings i pickup timken locally cheaper than the kits
Posted: September 22nd, 2009, 7:36 am
by Darrell262
I am hard on bearings, and let me tell you about all balls.
Complete crap. Low quality bearings.
I kept wearing out rear bearings on my street bike, I figured it was from wheeling and what not. replaced always with all balls seal and bearing kit.
I buy cr 500, rear bearings always fail, replace with all balls,
ktm 300 which I ride all the time always rear bearings go. this year alone I have replaced the rear bearings 2 times now. in 1 fricken year.
I asked dealer I get my parts from wtf gives? I know I am hard on stuff but come on. They ordered pivit works tihs time. Alittle more expensive but so far havn't worn out. I have had it with all balls. I am not going to order them anymore.