BannedCR500Riders.com

anybody running a stock steelie wheel, if so what brake rotor did you use with the gen3 brake? or should i run a modded caliper bracate

i have a '91 500 wheel i'll likely swap gen3 axel size bearings into instead of running my small i.d. adjusters but want to sort out the brake deal first

anything a half breed, like big bolt hole rotor, but gen3 diamiter?

when i cross referenced my excels that i bought i found that they are the same # of holes as the crf's so you could just lace up a gen 3 hub to the steelie rim if you had a spare hub somewhere.

Maybee I'll have to do that, I was going to swap the 18" hubs bearings for the af sized ones, and try to get a rotor mounted that'd work. Thanks for checking that out