Bore cylinder in lathe?
Posted: June 24th, 2009, 7:18 am
Has anyone done that?
Cons?
Janne
Cons?
Janne
but, if you are asking us, you probably shouldn't attempt it..
or at least practice on a junk cylinder first....BannedCR500Riders.com
Addressing the survival of the legendary CR500!
https://www.bannedcr500riders.com/
Bore cylinder in lathe?
Page 1 of 1
Posted: June 24th, 2009, 1:15 pm
guys do it. it can be done.
but, if you are asking us, you probably shouldn't attempt it.. or at least practice on a junk cylinder first....
but, if you are asking us, you probably shouldn't attempt it..
or at least practice on a junk cylinder first....Posted: June 24th, 2009, 1:20 pm
GSS for that service myself.
Posted: June 24th, 2009, 8:16 pm
Don't like the sound of that.
Posted: June 24th, 2009, 10:05 pm
cr500 is very durable.
Posted: June 24th, 2009, 10:10 pm
I hope so.
Posted: June 24th, 2009, 10:22 pm
Takes a lickin' its never tickin'
Posted: June 24th, 2009, 10:25 pm
Run that by me again.Posted: June 24th, 2009, 10:32 pm
CR500 takes a licking(tongue) its never ticking(valves)
Posted: June 24th, 2009, 10:33 pm