Question about Water Outlet on 88 Cylinder
Posted: June 21st, 2009, 7:16 pm
So most of you know I had a hard time getting my cylinder head off. Well I guess the water outlet pipe on the rear of the jug came loose while doing that. I was cleaning it up today and noticed that I could turn it so I pulled on it and it came right out.
I guess my question is, what was holding this in, in the first place? And can I get it to stay in there without welding it?
Both mating surfaces are completely smooth, and it is a fairly tight fit. I don't see anything that could have been keeping it from coming out. I looked at a parts diagram and didn't see that the outlet was a separate piece.
I guess my question is, what was holding this in, in the first place? And can I get it to stay in there without welding it?
Both mating surfaces are completely smooth, and it is a fairly tight fit. I don't see anything that could have been keeping it from coming out. I looked at a parts diagram and didn't see that the outlet was a separate piece.
