BannedCR500Riders.com

Someone from the board sold Roosty a "bitchin" PWK with a worn out float axle.

This shit better stop.... SOON!

AlisoBob wrote:

Someone from the board sold Roosty a "bitchin" PWK with a worn out float axle.

This shit better stop.... SOON!

I gave him one, it aint that one is it?

Hey, didn't you send him a little one recently?
http://bannedcr500riders.com/board/viewtopic.php?t=6163

Exnav wrote:Hey, didn't you send him a little one recently?
http://bannedcr500riders.com/board/viewtopic.php?t=6163

Oh yea......

hey, where the heck did that picture come from?
I gotta admit i was a little too eagar and called Bob to see if i'd lost a PWK pin somewhere that had a step or something, once I got looking arround i found a small box labeled "Higginson Bushings", I installed it and everything works Perfect, dont know what the "shitty carb" comment was all about

Bob,I still need a slide 6.0 And a needle with the clip for a pwk 38 to a 41 whatever they all will interchange.If he's not going to use them I would be intersted .Glen

I dont have a slide Glenn.

Check your PM's....

how does a float axle get worn out like that???

I only turn left

and 3 lefts make a right

AlisoBob wrote:I only turn left

But seriously, I cannot understand. My guess would be abnormal wear, like someone had no clue what they were doing and screwed it up removing the pin.

I personally unbolted the carb from a 1997 KX500 at the scrap yard.

Looking for full answers here. Not trying to be a buttwad. I'm just amazed that would EVER happen to a carb. It's like buying a house and then finding out later the foundation is missing on one side.

When did you pull the carb? (As in the date xx/xx/xxxx)