My Teem Trubble Build
Posted: December 6th, 2008, 5:10 pm
ok guys its almost done, i had a couple of parts that were miss shipped but i was at teem trubble last night and here is a sneek peek of my bike, the correct parts will be in early next week and then its time to put this bad boy in my living room 
as promised a list of what i did and what it cost.
Base Bike:
2006 CR125R
What I did:
Teem Trubble works 500 conversion - Frame, sub frame and swing arm and shock linkage were polished then scotch brited for final finish -CRF250F radiators – maxxis IT tires – excel 21”&19” rims – new hd tubes and new rimlocks– sunline rimlock hardware - stainless spokes with spline drive nipples – excel pro hubs – excel hub carriers – ebc contour rotor in the rear – ebc oversized 280mm contour rotor front – custom teem trubble axel carriers – sunline 14/48 chain wheels – sunline axel blocks – t.m. designs chain slider, block and roller- RK chain- sunline stainless pegs – sunline shifter – sunline rear brake lever with clevis – boyessen clutch and ignition covers – pro circuit pipe and s/a silencer – zero time motor, ported and then green diamond blasted for finish – sudco 41mm carb – eibach coil – rear shock was polished – forks were anodized black with polished lowers and built by TTM – azonic polished upper clamp with polished stock lower clamp – sunline avi bars – sunline mdx brake lever – sunline mdx v1 clutch lever and perch – full sdg seat – plastics, splash guard and radiator guards, black – ktm black number plate – motar front fender- lightspeed front brake clamp – lightspeed rear caliper and disc guard – ready filter airfilter with filtron alloy air filter screw – spyder grips – urban camo graphics – pro moto billet kickstand. That’s all I can think of right now.
i will have alot of quality photos when its 100% done next week
total cost of build $9,800.00
as promised a list of what i did and what it cost.
Base Bike:
2006 CR125R
What I did:
Teem Trubble works 500 conversion - Frame, sub frame and swing arm and shock linkage were polished then scotch brited for final finish -CRF250F radiators – maxxis IT tires – excel 21”&19” rims – new hd tubes and new rimlocks– sunline rimlock hardware - stainless spokes with spline drive nipples – excel pro hubs – excel hub carriers – ebc contour rotor in the rear – ebc oversized 280mm contour rotor front – custom teem trubble axel carriers – sunline 14/48 chain wheels – sunline axel blocks – t.m. designs chain slider, block and roller- RK chain- sunline stainless pegs – sunline shifter – sunline rear brake lever with clevis – boyessen clutch and ignition covers – pro circuit pipe and s/a silencer – zero time motor, ported and then green diamond blasted for finish – sudco 41mm carb – eibach coil – rear shock was polished – forks were anodized black with polished lowers and built by TTM – azonic polished upper clamp with polished stock lower clamp – sunline avi bars – sunline mdx brake lever – sunline mdx v1 clutch lever and perch – full sdg seat – plastics, splash guard and radiator guards, black – ktm black number plate – motar front fender- lightspeed front brake clamp – lightspeed rear caliper and disc guard – ready filter airfilter with filtron alloy air filter screw – spyder grips – urban camo graphics – pro moto billet kickstand. That’s all I can think of right now.
i will have alot of quality photos when its 100% done next week
total cost of build $9,800.00
