Page 1 of 1
Brake pedal issue
Posted: July 21st, 2008, 6:04 pm
by eyesky2002
Posted: July 21st, 2008, 7:19 pm
by teemtrubble
You have to tweak it.
Posted: July 21st, 2008, 7:27 pm
by eyesky2002
teemtrubble wrote:You have to tweak it.
With or with out heat?
Posted: July 21st, 2008, 7:29 pm
by eyesky2002
Oh ya... Got that silencer last week! Looks great! Thanks Mike!!!!
Posted: July 21st, 2008, 7:32 pm
by teemtrubble
Your welcome I send them out for anneal with my other stuff then heat treat but, it should bend maybe "There's my disclaimer"
Posted: July 21st, 2008, 7:53 pm
by KE 336
I don't think I'd panic just yet. Kind of hard to tell from the angle of the top photo but, I looks like the pedal is well above the foot peg. Lay a straight edge across the foot peg and see how it looks with the pedal slightly below the peg.
Posted: July 23rd, 2008, 6:55 pm
by Wheelie-Gene
Sit on the bike and see how it feels w/your foot on the pedal.
I like mine adjusted down past the top of the foot peg, but that's just me.
Looks like a small adjustment might fix it.
Posted: July 23rd, 2008, 7:20 pm
by MICK
Something I did to keep from scratching my clutch cover was to use a teflon washer between my brake pedal and frame. OD 27mm, ID 6mm x 2mm thick. Just thick enough to prevent metal to metal contact in any circumstance but a crash.
I've seen covers begin to leak because vibration and normal lever operation wore a hole through the aluminum.
We don't have the same cover, but yours appears to be positioned close to mine. I moved mine up when I was able to push it out.
Mind you I do not have my master cylinder (in the mail) yet, so maybe it is just sitting high and I am panicking 
Any ideas??? Here are a few pics...
