my swingarm
Posted: June 13th, 2008, 6:32 am
heres my + 6" swingarm i just got it back from my welder, it is truly a thing of beauty, almost looks factory nearly seamless.
BannedCR500Riders.com
Addressing the survival of the legendary CR500!
https://www.bannedcr500riders.com/
my swingarm
Page 1 of 1
Posted: June 13th, 2008, 3:23 pm
That definatly looks clean
Posted: June 13th, 2008, 4:19 pm
should of thrown up some more shots of yours brit
Posted: June 13th, 2008, 4:59 pm
i just wish i would have made it a half inch shorter, i didnt measure with me on it when planning it 
so with me on it it is 65 1/2" axle to axle. it should be fine if i dont have a picky inspector at the line.
so with me on it it is 65 1/2" axle to axle. it should be fine if i dont have a picky inspector at the line.Posted: June 13th, 2008, 5:25 pm
Why didn't you make it adjustable?
I always stand up and lift up on my rear fender when they measure.
My 500 is right at 66" with 14/50 gearing.
I always stand up and lift up on my rear fender when they measure.
My 500 is right at 66" with 14/50 gearing.
Posted: June 13th, 2008, 6:23 pm
well it goes from 65-1/2 to 66-1/4 , i had no time and low money so we took two swingarms and made one.
Posted: June 13th, 2008, 6:26 pm
when they measure is it center of axle to center or outside to outside? how does the go- no go stick work? this is the first time i will have to be measured, i always ran open -x before.