Page 1 of 1
pwk carb number. please assist
Posted: January 17th, 2008, 6:54 pm
by aloha450x
found a sweet carb on ebay for cheap, however he listed it as a pwk39as and as far as my knowledge(not saying much) is that only the 39 is not an "as" so i asked for the part number on the side and g279 akfg is what he posted. here is the link. which carb is it?
http://cgi.ebay.com/ws/eBayISAPI.dll?Vi ... 0198161034
Posted: January 17th, 2008, 7:04 pm
by aloha450x
ok some quick visual research on ebay. i think it is actually a pwk 38as and not a 39. correct me if im wrong please
Posted: January 18th, 2008, 5:28 am
by lewisclan
THAT IS A GREAT CARB FOR A CR500
Posted: January 18th, 2008, 10:19 am
by AlisoBob
lewisclan wrote:THAT IS A GREAT CARB FOR A CR500
Yup....
Posted: January 18th, 2008, 10:33 am
by aloha450x
yeah but i think i need a 39 due to the fact it will be used for supermoto. correct? and that carb is a 38 as i think.
Posted: January 18th, 2008, 10:36 am
by AlisoBob
1mm difference aint nothin'....
The A/S feature is supposed to add in some torque... as in coming out of the corners....
Sounds S/M ready to me.,,,
Posted: January 18th, 2008, 10:39 am
by aloha450x
roger that. thanks bob but the carb is already at 152.00 and has a day left. i think im gonna keep looking
Posted: January 18th, 2008, 7:35 pm
by lewisclan
there is one on the other site right now for $70
Posted: January 20th, 2008, 10:53 pm
by M.F.D.B.
You can get that carb brand new for a little over $200 jetted and needled to your spec...
SUDCO...
Posted: January 21st, 2008, 7:31 am
by dannygraves
M.F.D.B. wrote:You can get that carb brand new for a little over $200 jetted and needled to your spec...
SUDCO...
X2
I got mine for cheep used off a kx500, then had to buy a needle, and jet it, then I had to replace the gasket and clean it out and replace the idle screw, etc. etc I honestly would have rather purchased new jetted to my spec, bolted it on, fine tuned and walked away.