Removing Swingarm endcaps
Posted: January 14th, 2008, 5:23 pm
HTF do you get the endcaps outa the swingarm so I can put the hillclimber extensions in??
Heat? Hammer? Both?
BobM
Heat? Hammer? Both?
BobM
BannedCR500Riders.com
Addressing the survival of the legendary CR500!
https://www.bannedcr500riders.com/
Removing Swingarm endcaps
Page 1 of 1
Posted: January 14th, 2008, 5:28 pm
Isn't there a couple of screws holding them in?
End Caps
Posted: January 15th, 2008, 4:07 am
I took the screws out already, they seem to be glued in also.
'
BobM
'
BobM
Posted: January 15th, 2008, 6:59 am
sorry I dident read this right away .....
you have to heat it up with a torch then remove the screws and slide hammer them out they are held in with epoxy
you have to heat it up with a torch then remove the screws and slide hammer them out they are held in with epoxy
Posted: January 15th, 2008, 7:01 am
What if you drill a small hole, dump in some gas...toss it into the fire pit.... and SOBE BOMB them out?
( Couldn't resist Jay!)
( Couldn't resist Jay!)
Posted: January 15th, 2008, 4:07 pm
that may also work
Posted: January 15th, 2008, 9:25 pm
Just let me know so I can move my truck. 