All Boinger, Sub-Tank, Steering Stabilizer Stuff Here.
BobM
Posts: 28 Joined: June 13th, 2007, 6:40 am
Location: Pomfret CT
Post
by BobM » January 14th, 2008, 5:23 pm
HTF do you get the endcaps outa the swingarm so I can put the hillclimber extensions in??
Heat? Hammer? Both?
BobM
britincali
Posts: 8207 Joined: May 31st, 2007, 7:10 pm
Location: Barstow, CA
Post
by britincali » January 14th, 2008, 5:28 pm
Isn't there a couple of screws holding them in?
Coolness list by 90cr500guy
Bob's = 50/50
Cepek = cool
Solidbro = cool
Brit = loser
Stoffer = 1 up from Brit
MFDB = cool
Danny = ok
BobM
Posts: 28 Joined: June 13th, 2007, 6:40 am
Location: Pomfret CT
Post
by BobM » January 15th, 2008, 4:07 am
I took the screws out already, they seem to be glued in also.
'
BobM
lewisclan
PVT. 1st Class
Posts: 4804 Joined: June 1st, 2007, 3:34 pm
Location: Yucca Valley CA
Post
by lewisclan » January 15th, 2008, 6:59 am
sorry I dident read this right away .....
you have to heat it up with a torch then remove the screws and slide hammer them out they are held in with epoxy
"the game of life of is not so much in holding a good hand as playing a poor hand well"
AlisoBob
"Hoon-father"
Posts: 15404 Joined: May 31st, 2007, 6:39 pm
Location: Aliso Viejo Ca
Post
by AlisoBob » January 15th, 2008, 7:01 am
What if you drill a small hole, dump in some gas...toss it into the fire pit.... and SOBE BOMB them out?
( Couldn't resist Jay!)
lewisclan
PVT. 1st Class
Posts: 4804 Joined: June 1st, 2007, 3:34 pm
Location: Yucca Valley CA
Post
by lewisclan » January 15th, 2008, 4:07 pm
that may also work
"the game of life of is not so much in holding a good hand as playing a poor hand well"
iggys-amsoil
Posts: 3602 Joined: June 1st, 2007, 6:09 pm
Location: Just North of March Airfield CA
Post
by iggys-amsoil » January 15th, 2008, 9:25 pm
Just let me know so I can move my truck.
Trinity Racing mild porting FMF
62 pilot, EGH needle, 172 main
03 Gen III CR250 frame
2013 Dodger Charger 5.7 Hemi
http://www.prisonplanet.com
Your Amsoil Customer #
350882