Page 1 of 1
Torque Specs
Posted: December 27th, 2007, 6:04 pm
by Exnav
Searched for this and did not find, but I am looking for the specs on the head and cylinder(not that you can get a socket on all of the cylinder nuts).
Anyone??? Bueller....Bueller.
Posted: December 27th, 2007, 6:09 pm
by HrcRacing
Cylinder is 29 ft/lb and the head are 20 ft/lb. You might want to buy a Motion-Pro adapter for the base nuts.
Posted: December 27th, 2007, 6:14 pm
by Exnav
Thanks for the info and tool suggestion.
Posted: December 28th, 2007, 8:33 am
by redrocket190
Remember to factor in the extra leverage from the length of the adaptor and reduce the torque setting to accommodate...
Posted: December 28th, 2007, 10:57 am
by 100hp honda
if you buy the motion pro tool (which i highly recomend you do), all the conversion factors will be included with the tool
Posted: December 28th, 2007, 1:42 pm
by HrcRacing
100hp honda wrote:if you buy the motion pro tool (which i highly recomend you do), all the conversion factors will be included with the tool
You are correct sir.